hier hebben we het over de geweldige x3 plus

[brunoschoofs]

[brunoschoofs]

does any one know the gcode fore to wipe the nozzle on the rubber thing at the back off the bed
everytime you start a print

[brunoschoofs]

this schould do it


M140 S60
M105
M190 S60
M104 S210
M105
M109 S210
M82 ;absolute extrusion mode
G12 C2
G92 E0 ; reset extruder
G29
G1 Z1.0 F3000 ; move z up little to prevent scratching of surface
G1 X2 Y20 Z0.3 F5000.0 ; move to start-line position
G1 X2 Y200.0 Z0.3 F1500.0 E15 ; draw 1st line
G1 X2 Y200.0 Z0.4 F5000.0 ; move to side a little
G1 X2 Y20 Z0.4 F1500.0 E30 ; draw 2nd line
G92 E0 ;
G1 Z1.0 F3000;
G92 E0
G92 E0
G1 F3600 E-0.5

[Bliss]

Does the job!

Enkel de Z offset aanpassen anders schraapt ze flink hard in het bed!

[brunoschoofs]

this is the 3mf file for the eSUN spool for refill filament with a hol from 80mm

eSUN refill spool A.stl

(7.32 MiB) 244 keer gedownload

eSUN refill spool B.stl

(6.96 MiB) 263 keer gedownload

bambu+spool+with+Holes.3mf

(4.39 MiB) 228 keer gedownload